A
PROFILE
UPM's Staff Profile
DR. MOHD SALAHUDDIN BIN MOHD BASRI
PENSYARAH KANAN
FACULTY OF ENGINEERING
UPM WEBSITE
PROFILE
salahuddin
BM
EN

PROFESSIONAL

NAME :
(Dr.) Mohd Salahuddin Bin Mohd Basri
POSITION :
Pensyarah Kanan
ENTITY :
Faculty Of Engineering

PUBLICATION
2021:
Rice Husk Ash/Silicone Rubber-Based Binary Blended Geopolymer Coating Composite: Fire Retardant, Moisture Absorption, Optimize Composition, and Microstructural Analysis
2021:
Effects of Different Fluting Medium Geometries on Von-Mises Stress and Deformation in Single Fluted Board: A Three-Dimensional Finite Element Analysis
2021:
Rice-Husk-Ash-Based Geopolymer Coating: Fire-Retardant, Optimize Composition, Microstructural, Thermal and Element Characteristics Analysis
2021:
Progress in the Valorization of Fruit and Vegetable Wastes: Active Packaging, Biocomposites, By-Products, and Innovative Technologies Used for Bioactive Compound Extraction
2021:
Membrane-based clarification of banana juice: pre-treatment effect on the flux behaviour, fouling mechanism and juice quality attributes
2021:
Novel Mangosteen-Leaves-Based Marker Ink: Color Lightness, Viscosity, Optimized Composition, and Microstructural Analysis
2021:
Rice Husk Ash-Based Geopolymer Binder: Compressive Strength, Optimize Composition, FTIR Spectroscopy, Microstructural, and Potential as Fire-Retardant Material
2021:
Operational and hygiene problems due to poor floor drain design and installation in a meat processing
2020:
DESIGN AND DEVELOPMENT OF ERGONOMIC TABLE AND ANALYZE USING RULA ANALYSIS
2020:
Optimizing the Processing Factor and Formulation of Oat-Based Cookie Dough for Enhancement in Stickiness and Moisture Content Using Response Surface Methodology and Superimposition
2020:
Clarification of guava juice by an ultrafiltration process: analysis on the operating pressure, membrane fouling and juice qualities
2020:
Optimization of Rice Husk Ash-Based Geopolymers Coating Composite for Enhancement in Flexural Properties and Microstructure Using Response Surface Methodology
2020:
Aerodynamic Drag Study of Time-Trial Cycling Helmets Using CFD Analysis
2020:
Investigation on Oil Absorption and Microstructural Properties of Polyethylene Composites Reinforced with Post-Agricultural Waste Fillers
2020:
Optimization of Adhesion Strength and Microstructure Properties by Using Response Surface Methodology in Enhancing the Rice Husk Ash-Based Geopolymer Composite Coating
2020:
Factorial design approach to investigate the effect of different factors on the fire resistance, compression and adhesion properties of geopolymer binder
2020:
Mass Modelling and Effects of Fruit Position on Firmness and Adhesiveness of Banana Variety Nipah
2020:
The Effect of Jackfruit Skin Powder and Fibre Bleaching Treatment in PLA Composites with Incorporation of Thymol
2020:
Design for manufacturability (DFM) of 3D printed parts fabricated using open source 3D printer